Smartstud Ped Crossing

Smartstud Ped Crossing

SmartPed is a reliable pedestrian detection system with precise boundaries. It consists of in-pavement tiles that detect pedestrians waiting to cross the street.
SmartPed alerts drivers most effectively in combination with smartstud lighting systems.

Show:
Sort By:
The coring drill must have a 1-1/4..
$0.00
The LED coring bit is a 92mm diamond bit capable of drilling a hole to a depth of 40mm.. This bit has a standard 1 ..
$0.00
The 24V model power supply unit is an Intelligent power supply for inductive systems.  This power unit is capable of powering 100m of IPH cable and Capable of powering 30 IPH Nodes and LED markers.  ..
$0.00
The two core IPH cable is made up of, plain annealed copper wire (PACW) conductors and special PE insulated (halogen free, non-flammable) unsheathed flat figure 8 cable. ..
$0.00
The IPH Node is a plastic cable separator at LED road marker locations.  Each marker requires a node separator between the cable to inductively couple power from cable to iiilevel..
$0.00
Smart10.2 adhesive is a two-part fast cure polyurethane elastomer with strong adhesive properties for adhering plastics or other substrate to a bitumen or bitumen aggregate road surface. ..
$0.00
SmartBase is a two-part fast cure epoxy used to create a solid base for on road LED markers. SmartBase is suitable for asphalt and concrete surfaces.   ..
$0.00
The stud stamp is a plastic removable mould used to create an even impression in base epoxy before you install the LED road marker.   ..
$0.00